rod mills commonly use steel rods with a diameter of 50-100mm as the grinding medium, while ball mills use steel balls as the grinding medium.
rolled alloy steel plate with lifter bars is available rod mill liners are subjected to severe impact. premature breakage and scrap loss are reduced by correctGet Price
the finesse of the material milled by the ball mill is 0.074mm-0.4mm, only except for the two small ball mills that have a wider range of 0.075-0.89Get Price
the breakage function results showed that any breakage event statistically produced less fines than in a ball mill. breakage rate data showed that the coarsestGet Price
g.w. heyes, d.f. kelsall, p.s.b. stewartcontinuous grinding in a small wet rod mill. part. i. comparison with a small ball mill. powder technol., 7 (1973), pp.Get Price
common types of grinding mills include ball mills and rod mills. this includes all difference between wet or a dry grinding mill grinding_mill. the choiceGet Price
the difference between rod mill and ball mill the grinding media of a ball mill is a steel ball the contact between the steel ball and the materialGet Price
as shown in the following figure, the length and flatness value of rod mill discharge are higher, while that of the ball mill is the opposite. theGet Price